SC2E-4133010 SC2E-4133020 SC2E-4107300 Rear Tail Lamp For BYD Atto 3 Yuan Plus 12V 18W Brake Turn Signal Reverse Light

This solid-state LED tail light assembly is engineered as a direct-fit replacement module for the 2022–2026 BYD ATTO 3 (Yuan PLUS), covering all regional trim specifications including the Base, Premium, and Honor Editions. Manufactured to achieve 1:1 physical and electronic parity with factory-installed equipment, this component provides verified catalog mapping for OEM Part Numbers: SC2E-4133010 (Left Hand / Outer Quarter Panel) and SC2E-4133020 (Right Hand / Outer Quarter Panel).

System Integration and Regulatory Specifications:

Chassis Interface: The mechanical housing matches original mounting points and factory panel apertures, facilitating a plug-and-play installation sequence without requiring body modifications, wire-cutting, or control-module flashing.

Electrical Architecture: Pre-wired to interface directly with the vehicle's native 12V electrical grid, the internal circuitry is calibrated to maintain seamless communication with the onboard diagnostic network.

Global Standardization: The lighting assembly is engineered to meet international road-safety benchmarks, carrying verified compliance with European ECE guidelines and North American DOT/SAE criteria for unrestricted global distribution and road use.

Tailored e-Platform 3.0 Alignment:

A true 1:1 precision-molded housing designed exclusively for the BYD Atto 3 / Yuan Plus. It mirrors the factory styling down to the finest detail, guaranteeing that your SUV retains its premium electric vehicle appeal.

Hassle-Free Pin-to-Pin Installation:

Designed for straightforward DIY garage replacement. The unit features an exact factory-spec wiring harness connector that interfaces directly with your Atto 3’s native 12V electrical framework. Simply unbolt the damaged unit, snap the new connector into place, and secure it—no wire splicing or ECU recoding required.

All-Weather Climate Shielding:

Given that crossover SUVs are frequently exposed to diverse environments, this tail lamp utilizes a fully sealed, ruggedized housing. It successfully insulates sensitive solid-state diodes from high-pressure car washes, road salt, and dense humidity, preventing internal water droplets and fogging.

Advanced Anti-Aging Lens Treatment:

The heavy-duty lens substrate is treated with an advanced chemical hard-coating and UV-inhibitor barrier. This deep protection prevents the lens from yellowing, clouding, or developing hairline heat cracks over years of outdoor parking and intense sun exposure.

Debris & Vibration Resistance (Rated >=10J): Engineered to withstand the vibrations of rough roads and highway driving, the impact-resistant structure is rated at >=10J. The high-strength ABS backing effortlessly deflects flying stones, gravel, and minor rear impacts without cracking.

Full Matrix Lighting Functionality:

This integrated light engine fully replicates all original rear signaling layouts on an efficient 12V/18W circuit. Utilizing high-intensity Surface-Mount Diode (SMD) arrays, it provides instantaneous luminance for your Brake Lights, Dynamic Turn Signals, Position Lights, and Reverse Lights.

Enhanced Photometric Road Safety:

Drive with complete confidence. The upgraded LED chips emit a highly concentrated, wide-angle light distribution that cuts through heavy rain, night darkness, and dense fog. This maximum rear visibility gives trailing drivers immediate warning, significantly reducing rear-end collision hazards.

Validated Thermal Endurance:

Rigorously tested under extreme laboratory temperature cycles—from freezing sub-zero conditions to scorching trunk heat—ensuring consistent voltage regulation and zero hyper-flashing or premature LED burnout.